Blended Finish Blanket Chest

Updated on: Published on:
Woodworker applying whitewash finish to wooden fireplace mantel in workshop setting

 

My dad purchased an older home that he eventually tore down, but there were a few treasures to be found amongst the rubbish before that occurred. A Lane cedar chest was one of them, and it still had the original documentation in it. After he cleaned it up a little, it wasn’t half bad, other than the smell inside. I didn’t get a true “before” pic but trust me, it was gross.

 

Wooden blanket chest with multiple small drawers and brass handles on a stone floor

 

I had been wanting something for the end of our bed, and this chest was going to be the perfect fit! When I brought it home, I kept the chest open for several weeks to air it out, but it kept a funky smell. We’ll address that in a minute.

Open cedar blanket chest showing interior with green felt-lined tray and wood grain details
Inside of cedar chest with papers still intact
Wood branding stamp Virginia Maid by Lane on finished cedar wood panel of blanket chest
The chest was Virginia Made by Lane

I chose to paint it to match my décor so I used a blend of General Finishes Perfect Gray and Key West Blue Milk Paints. But the first thing needed was a thorough cleaning of the surface with some Krud Kutter.

Two cans of General Finishes water-based milk paint in Perfect Gray and Key West Blue on a wooden surface.

Paint used: General Finishes Milk Paint - Perfect Gray and Key West Blue

Krud Kutter paint cleaner spray bottle and used white cloth on wooden workbench surface
Use Krud Kutter to clean and degloss surfaces before painting. 

 

Next I removed all of the hardware (besides the lock) and set it aside.  I taped around the lock itself to avoid getting paint on it.

An “oops” moment occurred when some of the trim pieces came off, but no worries. A little Titebond Ultimate Wood Glue did the trick.

 

Hand using a screwdriver to remove or adjust a screw inside a wooden blanket chest drawer.

I removed the hardware and set it aside. 

Woodworker holding a stained wood sample strip against a blanket chest panel for color matching.
Woopsy! A couple pieces of trim came loose while I was cleaning the chest.
Titebond Ultimate wood glue bottle on a finished wooden blanket chest panel with visible joinery lines

Titebond Ultimate Wood Glue to the rescue!

 

Then I was ready to start painting. One coat of Perfect Gray went on first. Normally I would probably do two, but I knew I would be adding more paint in order to achieve the blended look.

 

 

For the next step, I started on the upper sections of the front of the chest, adding some of the Key West Blue in the middle part of each square. With the brush I used for the Perfect Gray, I came back and lightly blended the blue into the gray. I did the same thing on the two faux drawers.

Applying light-colored paint with a brush to a wooden blanket chest panel in a workshop setting
One coat of GF Perfect Gray Milk Paint
Hand applying blended finish with brush on wooden blanket chest panels in workshop setting
Starting to blend the Key West Blue in with the Perfect Gray

 

I continued on the bottom edge, the sides and the top of the chest in the same manner. Now, if you try this and the blended areas don’t look good to you, give them a spritz of water and reapply. I did that more than once.

The entire piece got two coats of Flat GF High Performance Topcoat.

 

Wooden blanket chest with primer coat drying on drop cloth surrounded by paintbrushes and finishing supplies

 

The eight little knobs got a refresh with Rust-Oleum Dark Bronze Hammered Paint. I found some different hardware for the faux drawers in my stash and spiffed them up to match. Once dry, I screwed all of the hardware in place.

 

Hand spraying Rust-Oleum protective finish on metal hardware pieces for woodworking project.
The old knobs got refreshed with Dark Bronze Hammered Paint from Rust-Oleum.
Two oval wood drawer pulls with decorative beading drying on newspaper after finishing application
The faux drawer hardware was switched out and painted to match the knobs.

 

Now, remember the funky smell? I used some Howard Orange Oil Wood Polish on the interior of the chest and not only did it remove the smell, but the cedar looks gorgeous now.  This product contains real citrus oils to clean, polish and preserve the beauty of the wood. Isn’t that pretty?

 

Close-up of cedar wood planks with knots and a circular wood stamp inside a blanket chest interior

 

And here is my treasure in its new home. I think it’s perfect!

Don’t be so quick to declare something as junk. Often a little elbow grease is all you need to polish that diamond in the rough!

 

Blended finish wooden blanket chest with drawers at foot of bed in bedroom setting

 

For more tips on color blending, read How To Achieve Beautiful Blended Finishes.

Need some help turning your find to fantastic? Stop by your local Woodcraft store for advice on the products, tools and supplies you need to get it done right. We’re here to help!

 

woman in workshop setting with necklace, posing for woodworking blog header

 

We hope you’ll be inspired!

 

Back to blog